mass spectrometry comes up often in conversation and rarely with the context attached. Here we lay out the basics in order, then work through the practical considerations.
Last reviewed on 2025-09-18. Where a claim depends on a specific study, the study is described rather than over-claimed.
Reconstitution is the process of dissolving a dried peptide in a suitable solvent. The choice of solvent depends on solubility, charge, and sequence; sterile water is common, while buffers or small amounts of organic solvent may be needed for hydrophobic peptides. Adding solvent gently down the vial wall and mixing by inversion or gentle swirling reduces foaming and shear. Vortexing or vigorous pipetting can denature some peptides or promote aggregation. The resulting solution should be visually inspected for particles, turbidity, and complete dissolution before use.
After reconstitution, solutions are usually divided into single-use aliquots to avoid repeated freeze-thaw cycles. Aliquots should be labeled with peptide identity, concentration, solvent, and date, then stored at the temperature specified by the supplier or protocol. Many peptides tolerate -20 °C for short periods, while -80 °C is preferred for longer storage. Frost-free freezers are generally avoided because temperature fluctuations can stress samples. Aseptic technique and sterile filters reduce microbial contamination, though filtration can also remove aggregated material or bind some peptides.
Peptides are short amino acid polymers whose stability depends on sequence, length, and chemical modifications. In dry form, most peptides are relatively stable because low water activity slows hydrolysis and other degradation. Residual moisture, oxygen, and light can still promote oxidation, deamidation, or aggregation over time. Storage recommendations therefore usually combine low temperature, desiccation, and protection from light. Because each peptide has distinct properties, no single condition fits every sequence.
Temperature selection balances degradation rate against physical changes. Many lyophilized peptides are stored at -20 °C, while some modified or longer sequences require -80 °C for extended periods. Aqueous stock solutions are less stable and are often kept at -20 °C or below in single-use aliquots. Repeated freeze-thaw cycles can cause aggregation, precipitation, or loss of activity, so aliquoting before freezing reduces that risk. Frost-free freezers cycle above freezing and may be unsuitable for long-term peptide storage.
Container and environment choices matter. Peptides may adsorb to glass, plastic, or filter membranes, especially at low concentrations. Low-binding tubes and inert containers reduce loss. Moisture barriers include sealed bags with desiccant, and light protection uses amber vials or opaque wraps. Inert gas blankets can limit oxidation for sequences containing methionine, cysteine, or tryptophan. Buffers and pH also affect solution stability; extremes of pH accelerate hydrolysis and deamidation. These practices apply to research and manufacturing settings, not to any specific clinical use.
| Property | Value | Notes |
|---|---|---|
| Reconstitution solvent | Sterile water or aqueous buffer | Organic cosolvent may be needed for hydrophobic sequences |
| pH adjustment | Sequence-dependent | Test small volumes before preparing the full solution |
| Filtration | 0.22 µm sterile filter | Can remove particles but may bind or remove aggregates |
| Aliquot size | Single-use volume | Reduces repeated freeze-thaw cycles |
| Post-reconstitution storage | -20 °C to -80 °C | Follow supplier or protocol; avoid frost-free cycles |
Reconstitution introduces additional variables: solvent choice, pH, ionic strength, and filtration. Many sequences dissolve readily in water, while hydrophobic ones may need acetonitrile, dimethyl sulfoxide, or a small amount of base. Adding solvent slowly and avoiding vigorous vortexing can reduce foaming and shear-induced aggregation. If the solution appears cloudy, filtration may remove particulates but can also remove aggregated peptide and alter concentration. A clear solution does not by itself confirm correct sequence or purity, so analytical checks remain necessary.
Temperature logs and cold-chain documentation help identify excursions that may compromise a batch. Automated freezers, desiccant packs, and sealed containers limit moisture and frost accumulation. Aliquoting small portions before freezing reduces the number of times the main stock changes temperature. Labels should include peptide name, lot, concentration if known, solvent, and date prepared. Periodic analytical verification by high-performance liquid chromatography or mass spectrometry can detect degradation, truncation, or sequence errors that visual inspection cannot reveal.
Practical handling begins with an inventory record that links each vial to a lot number, synthesis date, and purity certificate. Before opening a container, allow it to equilibrate to room temperature to prevent condensation on the powder. Weighing or transferring should occur in a low-humidity environment using tools that minimize static and adsorption. Hygroscopic peptides may gain water quickly, changing mass and concentration estimates. Recording the container's initial mass and any visible changes supports later reconciliation of material.
Light, oxygen, and pH influence peptide integrity through specific side-chain reactions. Methionine and cysteine residues are susceptible to oxidation, and tryptophan can degrade under strong light. Inert gas overlays and amber glass or opaque containers reduce these risks. pH affects charge, solubility, and the rate of deamidation or aggregation; a value that minimizes one pathway may increase another. The optimal pH and buffer for a given peptide are often determined experimentally, and open questions remain about predicting stability from sequence alone.
Peptides are short chains of amino acids linked by amide bonds, and their storage stability depends on sequence, length, and three-dimensional structure. Chemical degradation can occur through hydrolysis, oxidation, deamidation, and aggregation, while physical changes such as precipitation or surface adsorption reduce recovery. Storage conditions are chosen to slow these processes without altering the peptide itself. Because peptides vary widely, no single condition suits every sequence, so laboratories often establish stability empirically for each batch.
Temperature is a primary factor because most degradation reactions proceed more slowly at lower temperatures. Lyophilized peptides are commonly held at -20 °C or below, although some sequences remain stable at 2–8 °C for limited periods. Moisture uptake during handling can accelerate hydrolysis, so sealed containers and desiccants are used. Solutions are generally less stable than powders and may require freezing at -80 °C or refrigeration, depending on the peptide. Repeated freeze-thaw cycles can promote aggregation even when the storage temperature is otherwise suitable.
5-Oxo-ETE contracts smooth muscle and organ-cultured bronchi isolated from guinea pigs but relaxes bronchi isolated from human lung; the relaxation of human bronchi caused by 5-oxo-ETE may not involve its OXER1. These results suggest that 5-oxo-ETE is not directly involved in the bronchoconstriction) that occurs in eosinophil-based allergic asthma reactions in humans. 5-Oxo-ETE (or other 5-HETE family member) stimulates the growth and/or survival of human cell lines derived from cancers of the prostate, breast, lung, ovary, colon and pancreas These preclinical studies suggest that 5-oxo-ETE (or other 5-HETE family member) may contribute to the cited cancers progression in humans. 5-oxo-ETE stimulates human H295R adrenocortical cells to increase transcription of steroidogenic acute regulatory protein messenger RNA and produce aldosterone and progesterone by an apparent OXER1-dependent pathway. 5-Oxo-ETE induces an isotonic volume reduction in guinea pig intestinal crypt epithelial cells.
At first, regulatory RNA was thought to be a eukaryotic phenomenon, a part of the explanation for why so much more transcription in higher organisms was seen than had been predicted. But as soon as researchers began to look for possible RNA regulators in bacteria, they turned up there as well, termed as small RNA (sRNA). Currently, the ubiquitous nature of systems of RNA regulation of genes has been discussed as support for the RNA World theory. There are indications that the enterobacterial sRNAs are involved in various cellular processes and seem to have significant role in stress responses such as membrane stress, starvation stress, phosphosugar stress and DNA damage. Also, it has been suggested that sRNAs have been evolved to have important role in stress responses because of their kinetic properties that allow for rapid response and stabilisation of the physiological state. Bacterial small RNAs generally act via antisense pairing with mRNA to down-regulate its translation, either by affecting stability or affecting cis-binding ability. Riboswitches have also been discovered. They are cis-acting regulatory RNA sequences acting allosterically. They change shape when they bind metabolites so that they gain or lose the ability to bind chromatin to regulate expression of genes.
An anticancer drug is coupled to an antibody that targets a specific tumor antigen (or protein) that, ideally, is only found in or on tumor cells. The biochemical reaction that occurs upon attaching triggers a signal in the tumor cell, which then absorbs, or internalizes, the antibody together with the linked cytotoxin. After the ADC is internalized, the cytotoxin kills the cancer. Their targeting ability was believed to limit side effects for cancer patients and to give a wider therapeutic window than other chemotherapeutic agents, although this promise hasn't yet been realized in the clinic. ADC technologies have been featured in many publications, including scientific journals.
Sources: en.wikipedia.org
John J. Abel Award Julius Axelrod Award Pharmacia-ASPET Award in Experimental Therapeutics Robert R. Ruffolo Career Achievement Award Travel Award for Pharmacology Educators Bernard B. Brodie Award in Drug Metabolism P.B. Dews Lifetime Achievement Award for Research in Behavioral Pharmacology Drug Metabolism Early Career Achievement Award Goodman and Gilman Award in Receptor Pharmacology Benedict R. Lucchesi Distinguished Lectureship in Cardiac Pharmacology Torald Sollmann Award in Pharmacology Paul M. Vanhoutte Distinguished Lectureship in Cardiovascular Pharmacology Travel awards to participate in its meetings are also given to students and postdocs. Chemotherapy Clinical pharmacology Drug metabolism Neuropharmacology Pharmacology Toxicology Official website Molecular Interventions magazine
The standard botanical author abbreviation Tswett is applied to plants that he described. Ostrowski, W (1968). "Michael S. Tswett—inventor of column chromatography (On the occasion of 65th anniversary of his lecture on the column chromatography technique)". Folia Biol. (Krakow). Vol. 16, no. 4. pp. 429–48. PMID 4885242. R. Willstätter, A. Stoll, Untersuchungen über Chlorophyll, Springer, Berlin (1913) Biography of Mikhail S. Tsvet (pdf, in German) Mikhail S. Tsvet: Physical chemical studies on chlorophyll adsorptions Berichte der Deutschen botanischen Gesellschaft 24, 316–323 (1906)
Ancestim is a recombinant methionyl human stem cell factor, branded by Amgen as StemGen. It was developed by Amgen and sold to Biovitrium, now Swedish Orphan Biovitrum, in December, 2008. It is a 166 amino acid protein produced by E. coli bacteria into which a gene has been inserted for soluble human stem cell factor. It has a monomeric molecular weight of approximately 18,500 daltons and normally exists as a noncovalently associated dimer. The protein has an amino acid sequence that is identical to the natural sequence predicted from human DNA sequence analysis, except for the addition of an N-terminal methionine retained after expression in E. coli. Because Ancestim is produced in E. coli, it is nonglycosylated. Ancestim is supplied as a sterile, white, preservative-free, lyophilised powder for reconstitution and administration as a subcutaneous (SC) injection and is indicated for use in combination with filgrastim for mobilizing peripheral hematopoietic stem cells for later transplantation in certain cancer patients.
Several artificial nucleobases have been synthesized, and successfully incorporated in the eight-base DNA analogue named Hachimoji DNA. Dubbed S, B, P, and Z, these artificial bases are capable of bonding with each other in a predictable way (S–B and P–Z), maintain the double helix structure of DNA, and be transcribed to RNA. Their existence could be seen as an indication that there is nothing special about the four natural nucleobases that evolved on Earth. On the other hand, DNA is tightly related to RNA which does not only act as a transcript of DNA but also performs as molecular machines many tasks in cells. For this purpose it has to fold into a structure. It has been shown that to allow to create all possible structures at least four bases are required for the corresponding RNA, while a higher number is also possible but this would be against the natural principle of least effort.
Sources: en.wikipedia.org
It should first equilibrate to room temperature in a sealed container to prevent condensation on the cold contents. Opening too soon can introduce moisture and reduce stability, and the waiting period depends on vial size and packaging.
Hydrophobic peptides may require buffers, organic cosolvents, or a stepwise solvent approach. Small amounts of acetonitrile, methanol, or dimethyl sulfoxide are sometimes used, followed by dilution into aqueous buffer. The exact solvent system should be tested for the specific sequence.
Single-use aliquots limit freeze-thaw cycling, which can cause aggregation, precipitation, or loss of activity. They also reduce repeated opening of the same container and lower contamination risk. Labeling each aliquot supports traceability and consistent use.
Dry powders have low water activity, which slows hydrolysis and many chemical degradation routes. Solutions provide mobility and water for reactions, so they typically degrade faster even when refrigerated. Lyophilization itself does not make a peptide immune to oxidation or moisture uptake.